Wind Fairing for Front Runner Slimline II Platform Racks - 52-7/8" - 56-1/8" Wide

Video Transcript for Review of Front Runner Wind Fairing Slimline II Platform Rack - FR68ZV

Hi, everybody. Andy here with etrailer.com. Let's take a look at this wind fairing for your Front Runner Slim Line II Platform Racks. Now this aerodynamic fairing deflects air over your 52-7/8 inch to 56-1/8 inch wide Slim Line II Platform Rack. And this is going to help reduce wind noise and drag. And the sleek design is going to enhance the look of your rack.

Now let me go ahead and lay this down here and give you an overhead view. Line this up here just a little bit and I just wanted to give you some overall measurements just so you're aware of the size of this. So looking at the overall width from end to end, as you can see we're sitting right at almost 50 inches wide, about 49-7/8 inches wide. And then the overall height, we're sitting right at about almost 7 inches, I'm gonna say about 6-7/8 inches tall. And the fairing itself weighs just a little under 3 pounds.

And I did want to point out that low profile racks should use the Front Runner wind fairings for low profile racks. And so on your screen I'm including our item numbers for those fairings that are more designed for your low profile racks. And also I wanted to mention that this is not going to be suitable to be used on Jeep, the Jeep Wrangler, JK, JL or JT. So just so you're aware of that. Now the rubber seal here is going to eliminate gaps between the fairing and the roof.

And it's got a really good seal here at the bottom, flexible. So it's going to be able to fit into place and to close in that gap. And then you probably can't see it here on my table, but you're also going to get this clear protective strip that's going to prevent scuffs to your finish. So you're just going to peel this off of the backing here. And so that is included with this.

And these adjustable brackets are going to let you angle this fairing for the best performance. And so you can see that they're gonna move an be adjustable and hardware is included to mount this to your rack. And the fairing itself features this perforated punch out section here to accommodate your center front antenna if you have one or shark fins. And I do wanna point out as well this may interfere with sunroof operation on some vehicles. And this is going to be an easy installation on the front bottom channel of your Front Runner Slim Line II Platform Rack. And again, with the included brackets and hardware. And the black powder coated aluminum is going to be very durable, but it's also going to be lightweight and hold up really well. It's gonna resist that rust and corrosion, so you're not gonna have to worry about that. Well, that's gonna wrap up our look today. I do hope that it was helpful for you. Again, my name is Andy. Thank you for joining me.